Change your channel as a precautionary measure to avoid the few neighbors you do have. If you live in the middle of nowhere, more likely than not too many neighbors is not your issue. Last week’s blog post demoed this little trick to avoid interference from nearby neighbors. Change the channel of your wireless router.Pick your wireless router up off the floor.Įlevating your router will keep it away from building materials in the floor, like cement and metal, that block radio waves.If the band is congested, switch these electronics off or go for 5.0 GHz alternatives. Microwaves, cordless phones, baby monitors, VoIP, Bluetooth, medical equipment, satellite, closed-circuit television, and leaky electrical wiring emit same 2.4 GHz radio waves as Wi-Fi. Switch other household electronics off.Instead, install it in a window or in the room (office or living room) where you need reliable Wi-Fi the most. Don’t put your wireless router in the attic. The closer your device is to the router and window facing the location of the cell tower, the faster it will transmit online data. Move your wireless router to a central indoor location next to a window always. If you have access to 4G LTE where you live a MIMO – multiple inputs, multiple outputs – booster antenna will increase the potential throughput of your network exponentially at least 2-3 times. Multi-directional booster antennas improve the range and efficiency of the Wi-Fi broadcast inside your residence. Test the antenna at every 10-degree increment horizontally and, if the nearest cell tower is at a higher elevation, test directing the antenna slightly upwards. Use a cell phone in test mode to perfectly position your antenna to achieve the maximum dB of signal gain. Well, they will just literally drop.Īn elevated external antenna not only transmits more directly with cell towers (which are typically built on a high elevation), but also transmits over vegetation, nearby buildings, and geological features that would typically cause interference. Clearing trees and brush that are in the direct line of sight between these two will prevent data packets from getting caught in the branches. Vegetation causes interference between your antenna and the cell tower it transmits with. Please make sure to get the required training before engaging the saw. Clear the line of sight between your external antenna and the closest cellular tower.ĭo you own a chainsaw? Well, this might just be the right place to use it.Furthermore, just consider Moore’s Law – the idea that the capabilities of electronics double every two years – means that internet hardware over two years old is significantly less efficient than newer hardware. Since rural coverage is already dodgy, users can’t afford cheap antennas, routers, modems, cords, or connectors. The quality and age of hardware have a huge effect on data throughput and packet loss. Replace old or damaged routers, modems, cords, and connectors.However, if you are located in a mountainous or forested area, you should consider an Omni-point antenna. Choose a directional antenna, like a Yagi, which concentrates transmissions in one direction and, therefore, gets better range.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |